BotRescueBotRescue

No Loop Signal

Husqvarna: Boundary Wire Signal Lost

Applies to: Husqvarna Automower, Worx Landroid. Meanings can vary by model — trust the voice alert on your unit.

What causes it?

“No loop signal” means the mower cannot detect a complete boundary (and sometimes guide) wire loop from the charging station. A flashing blue station lamp usually points to a break or bad connection; solid green with no signal points to distance, layout, interference, or ECO mode.

How to fix it

  1. At the charging station, reseat boundary and guide wire ends until contacts are clean and fully inserted.
  2. Inspect splices and look for cuts from gardening or weather.
  3. If the lamp still flashes blue, bisect the loop to find the break and repair with a waterproof coupler.
  4. If the lamp is green but the mower still reports no loop, check ECO mode, max distance from the wire, and interference — then create a new loop signal in settings or contact a dealer / BotRescue for installation help.

Boundary Wire Signal Lost — fix guides by model

Dock layout, brush position, and parts differ by model — open the guide for your unit.

Still stuck?

Run free diagnosis for a guided path, or book a Brisbane meetup if DIY is not enough.