BotRescueBotRescue

Roborock S8 MaxV Ultra Repair Brisbane

Match your symptom to a DIY guide below. Prefer a guided path? Start free diagnosis — meetup or mail-in only if DIY stops.

Symptoms → DIY guides

Each card opens the full fix guide for this model.

Error 1: Top laser sensor (LDS) not spinningmedium →

Error 1 — LiDAR turret jammed, blocked, or not spinning so the robot cannot map. Cleaning is DIY; a tower that still will not spin after freeing usually needs an LDS module service.

Error 5: Main brush jammed (underside roller)easy →

Error 5 — hair or debris wrapping the main brush, ends, or installation slots. Recurring Error 5 after a thorough clean often means a failed brush motor or gearbox.

Error 13 / charging error — will not charge on dockmedium →

Error 13 (charging error) or the robot sits on the dock but battery % does not rise. Official steps cover oxidised contacts, dock power, and cable seating before any battery swap.

Dock will not empty the dustbin (full diagnostic)medium →

Auto-empty does not start, or starts but leaves dust in the bin / makes unusual noise. Goes beyond app toggles into bag, brush cover, and air-path blockages from the official Ultra manuals.

Dock status light steady red (tank / bag / water filter)medium →

Dock LED stays steady red — official Ultra troubleshooting: dustbin/bag seating, voltage, clean/dirty tank placement, and water filter click-lock.

Dock will not wash the mop (tanks + water filter)medium →

After mopping, the dock does not wash the mop. Official Ultra steps require job-started-from-dock, tank seating, and a correctly click-locked water filter — not just an app Wash tap.

Error 42: Dock maintenance brush jammedmedium →

Error 42 — dock maintenance brush jammed. Left-side stop = physical jam; right-side stop = water filter blocked or not seated (S8 Pro Ultra / Saros manuals).

Fan speed lowered / weak suction — filter blockedmedium →

Official “fan speed lowered” guidance: check a blocked strainer/filter and replace the filter if cleaning does not restore suction. Wet filters must dry thoroughly before reuse.

Error 18: Vacuum fan errorhard →

Error 18 — vacuum fan fault. Official manuals say reset the system after clearing filter/dustbin issues. Recurring Error 18 is not a DIY fan swap for most owners.