BotRescueBotRescue

LiDAR turret blocked — Error 1

Where to look: underside / top sensors as described in the steps.

Roborock Error 1 means the LiDAR (LDS) turret or laser is blocked or not spinning, so mapping fails. Official step: watch the laser unit spin; free it by hand if jammed.

_Legacy Roborock brand hub guide — steps match official Error tables for S7/S8/Q-class robots._

What you might notice

  • Error 1 / LiDAR turret or laser blocked
  • Laser tower does not spin at start-up
  • Robot fails to map or cleans in a small circle

Can I DIY this?

Easy DIY (~10-20 min). Follow the steps once. Stop if you hit sealed motors or a lithium pack — use meetup / mail-in.

What you need

  • Soft dry cloth
  • Optional: canned air

Do this

    • Power on and watch the laser unit — it should spin smoothly.
    • If it does not spin, gently rotate it by hand about one full turn to free hair or grit, then restart.
    • Wipe dust around the tower with a soft dry cloth. Do not force the housing open or spray liquids into the turret.
    • Run a short clean. If Error 1 returns with a free-spinning tower, request LDS module repair rather than opening sealed electronics.

Parts (only if cleaning fails)

  • LDS / laser module (service)

Official references

  • https://support.roborock.com/hc/en-us/articles/360035369092-What-should-I-do-when-error-1-occurs
  • https://support.roborock.com/hc/en-us/article_attachments/8737236175641

Still stuck?

Free diagnosis · Brisbane meetup / mail-in

Parts for this fix

Prefer buying the part and DIY when safe — round-trip postage often rivals a new machine. Ship docks only if we ask.

Parts link →

As an Amazon Associate, BotRescue may earn from qualifying purchases. Prices and stock are on Amazon AU. · campaign guide-roborock