BotRescueBotRescue

Drive wheels jammed — Error 7

Where to look: underside / top sensors as described in the steps.

Roborock Error 7 means a drive wheel cannot turn (hair around the axle or grit in the wheel well). Official step: press and spin the wheels by hand to free them, then move the robot and restart.

_Legacy Roborock brand hub guide — steps match official Error tables for S7/S8/Q-class robots._

What you might notice

  • Error 7 / wheels jammed
  • Spinning in place or pulling to one side
  • Wheel will not spin freely by hand
  • Robot stuck after climbing a threshold

Can I DIY this?

Medium DIY (~15-30 min). Follow the steps once. Stop if you hit sealed motors or a lithium pack — use meetup / mail-in.

What you need

  • Soft cloth
  • Tweezers or pick
  • Flashlight

Do this

    • Power off. Flip the robot and press/spin each drive wheel by hand.
    • Clear hair and grit from both wheel wells and axles until each wheel turns freely.
    • Place the robot on open flat floor and restart cleaning.
    • If a wheel still binds after a thorough clean, or Error 7 returns immediately, request wheel-module repair.

Parts (only if cleaning fails)

  • Drive wheel module (service)

Official references

  • https://support.roborock.com/hc/en-us/articles/360035369212-What-should-I-do-when-error-7-occurs
  • https://support.roborock.com/hc/en-us/article_attachments/8737236175641

Still stuck?

Free diagnosis · Brisbane meetup / mail-in

Parts for this fix

Prefer buying the part and DIY when safe — round-trip postage often rivals a new machine. Ship docks only if we ask.

Parts link →

As an Amazon Associate, BotRescue may earn from qualifying purchases. Prices and stock are on Amazon AU. · campaign guide-roborock