BotRescueBotRescue

Pudu SwiftBot: Charging failure / will not auto-dock

Where to look: Charging pile contacts, adapter, and mapped pile location.

Charging failure, or robot will not auto-return to the charging pile.

_For Pudu SwiftBot, confirm power/loop/dock basics before any sealed motor work._

Picture

Charging failure / will not auto-dock

What you might notice

  • Pile red light
  • Does not auto charge

Can I DIY this?

Easy DIY (~10-20 min) on Pudu SwiftBot. Clear debris first; replace a worn brush/filter only if cleaning fails. If the same alert comes back after a clean install, book a Brisbane meetup.

What you need

  • Soft clean cloth

Do this

    • Confirm robot power/key switch allows charging; check charger/adapter indicator is on.
    • Place pile against a flat wall on dry floor with ~100 cm front / 50 cm side clearance; keep pile in its mapped position.
    • Use only one correct adapter (3.5A/8A/15A per model table). Blue=standby, green=charging/docking, red=abnormal — disconnect if red persists.
    • Wipe pile and robot charge plates with a soft clean cloth (every few weeks on CC1).
    • Enable Auto charging in settings only after the pile location was set during mapping. If still failing, contact Pudu support.

Parts (only if cleaning fails)

  • None for a basic clean

Official references

  • https://academy.pudutech.com/en/docs/charging-station-qsg
  • https://static.generation-robots.com/media/pudubot2-guide-operation.pdf
  • https://static.generation-robots.com/media/user-manual-pudu-swiftbot.pdf
  • https://academy.pudutech.com/en/docs/PUDU-CC1-Operation-Guide-V6

Still stuck?

Free diagnosis · Brisbane meetup / mail-in

Parts for this fix

Prefer buying the part and DIY when safe — round-trip postage often rivals a new machine. Ship docks only if we ask.

Parts link →

As an Amazon Associate, BotRescue may earn from qualifying purchases. Prices and stock are on Amazon AU. · campaign guide-pudu-swiftbot