Error 1: Top laser sensor (LDS) not spinning
Where to look: The round laser tower on top of the robot.
Error 1 — LiDAR turret jammed, blocked, or not spinning so the robot cannot map. Cleaning is DIY; a tower that still will not spin after freeing usually needs an LDS module service.
Picture
Watch (similar Roborock models)
_Videos show related Roborock robots. Follow the written steps for Roborock Qrevo Edge._
Similar Roborock models — Error 1 laser check
What you need
- Soft dry cloth
- Optional: canned air
Do this
- Power on and watch the laser unit — it should spin smoothly.
- If it does not spin, gently rotate it by hand about one full turn to free it, then restart.
- Wipe dust/hair around the tower with a soft cloth. Do not force the housing open or spray liquids into the turret.
- Run a short clean. If Error 1 returns with a free-spinning tower, stop DIY — the LDS motor/module usually needs service.
- For Australia warranty/service, contact Roborock AU support rather than opening sealed electronics.
Parts (only if cleaning fails)
- LDS / laser module (service part)
Official references
- https://support.roborock.com/hc/en-us/articles/360035369092-What-should-I-do-when-error-1-occurs
- https://help.roborock.com/en-US/product/roborock-qrevo-edge
Still stuck?
Parts for this fix
Prefer buying the part and DIY when safe — round-trip postage often rivals a new machine. Ship docks only if we ask.
- LDS / laser module (service part)Search Amazon AU →
As an Amazon Associate, BotRescue may earn from qualifying purchases. Prices and stock are on Amazon AU. · campaign guide-roborock-qrevo-edge